How does the resistance spot weld fail?

Instructions:Type in the parameters and and press 'Make Graph'.

First Name:  

Last Name: 

Email:  

The email address and personal information provided in this webpage will not be shared with or sold to any third party or outside organization.

This takes about 45 seconds when the server is not busy, longer if it is.
If you get a "no data" result, please try again. If you continue to experience problems, contact skhurana@ewi.org

Schematic Illustration

Limitations

• Preliminary work and for evaluation only, so please do not use it.

References

• S. S. Babu, M. L. Santella, B. W. Riemer, J. W. Cohron and Z. Feng, Unpublished work

Disclaimer

The programs and procedures on this website are provided "AS IS" without warranty of any kind. EWI makes no warranties, express or implied, that the programs and procedures are free of error, or are consistent with any particular standard of merchantability, or that they will meet the requirements for any particular application. THE PROGRAMS AND PROCEDURES SHOULD NOT BE RELIED ON FOR SOLVING A PROBLEM WHOSE INCORRECT SOLUTION COULD RESULT IN INJURY TO A PERSON OR LOSS OF PROPERTY. Use of the programs or procedures in such a manner, it is at your own risk. Edison Welding Institute disclaims all liability for direct, incidental or consequential damages resulting from the use of programs or procedures on this website.

The information herein was prepared as an account of work sponsored by an agency of the United States Government at the Oak Ridge National Laboratory. Neither the United States Government nor any agency thereof, nor any of its employees, nor UT-Battelle or any other United States Government contractors, subcontractors or their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or any third party’s use or the results of such use of any information or process disclosed, ore represents that its use would not infringe privately owned rights